These LED's are Perfect accent lighting, Sensor Lighting, Turn Signal Arrays or just about anything else you can imagine, the posibilities are almost endless.

These LED's feature a small plastic shroud, this make installation a breeze, simply drill a hole and snap the Plastic Shroud in place, then insert the led and you have an LED Accent light, License place light or turn signal with a clean, professional look.

On my Honda 600rr (Pictured Below) I used them as a License Plate light, I installed 2 White LED's in my Rear Hugger, it took me about 30 minutes to install. The LED's have a very low profile so the wires do not get in the way of the tire, I used Epoxy to make the bottom of the Hugger watertight and protect the wires I had to run.

I also put 2 Blue LED's behind my Radiator, they glow very nicely at night. I will add another Blue LED to the rear eventually to balance the look.

My next project will use these in the front as Turn Signals, 3 or 4 on each side, hidden Below the Headlight.

Stats:

High Power

Wiring: Two Wire, 12 Volt Systems - They include Resistors

Bulb: 5mm High Intensity LED