Lighting - Relay - LED Flash Controller - 2 Pin Round

  • $12.99
  • Save $2
Shipping calculated at checkout.

Our LED Relay is intended to replace your OEM relay when installing aftermarket LED Turn Signals on your vehicle or when replacing a faulty existing Turn Signal Relay. This relay will prevent the hyperflashing caused by replacing stock Incandescent Bulbs with LED Lights. Replacing the Relay with an LED Relay is the easiest way to correct hyperflashing because it is a simple Plug-and-Play installation of only one part, with our relay you will not need to wire resistors to each individual signal, saving you time and money. Our Relay works with both LED's and Conventional Bulbs.

Multiple, please see photos
Housing: Black, High Impact Plastic
Plug: Two pin, 12 Volt Systems


Install Notes:
Install Notes: This LED Turn Signal Relay can be used as a replacement for almost all 2 Pin 12 Volt Relays. It will work on all Motorcycles and Automobiles that utilize a 12v 2pin Flasher Relay. Depending on your application it may be necessary to hard-wire the relay. A check of your OEM Relay and comparison of the Pin Layout will help you determine if this is the right relay for you. On Motorcycles, Relays are usually located under the side fairing, under the seat, or behind the instrument cluster. In Automobiles you will usually find them behind the dash or close to the fuse box. Pro Tip: Listen for the Clicking you hear when your signals are engaged to help locate the flasher relay.

Replaces these OEM Part Numbers:
(Will also fit other part #'s)